Specifications
Color: Yellow / Light Black / Dark Black / Matt Black
Material: PVC
Approx Size: Width 40cm, Length 180cm, Thickness 0.15mm
Self-adhesive material , Adhesive using heat gun, Stretchable with heat
 
How to install:

1. Clean the Headlights Thoroughly

- Wash the headlights with soap and water.
- Wipe them down with isopropyl alcohol to remove any grease or residue.
- Dry completely with a microfiber cloth.

2. Measure & Cut the Tint 
- Measure the headlight dimensions and cut the film slightly larger than needed (you’ll trim excess later).

3. Spray the Headlight & Film with Soapy Water
- Fill a spray bottle with water and a few drops of dish soap.
- Lightly spray the headlight surface and the adhesive side of the tint film (this allows repositioning).

4. Apply the Tint Film
- Peel the backing off the film and carefully place it on the headlight.
- Start from one edge and smooth it outward to avoid wrinkles.
- Use your fingers or a squeegee to push out air bubbles gently.

5. Stretch & Smooth with Heat
- Use a heat gun or hairdryer on low heat to soften the film.
- Stretch and smooth the film over curved areas, working out wrinkles as you go.
- Continue heating and smoothing until the film conforms to the headlight shape.

6. Trim Excess Film
- Once fully applied, use a sharp razor blade or utility knife to trim the edges carefully.
- Tuck any excess film behind the headlight housing if possible.

7. Final Smoothing & Drying
- Go over the entire surface with the squeegee to remove remaining water and bubbles.
- Let it dry for a few hours (or use heat to speed up curing).

8. Check for Bubbles & Imperfections
- If small bubbles remain, poke them with a needle and press flat.
- Reheat and smooth if needed.
 
Package Includes:
1 Roll Headlight tint film